Skip to content

24/7 emergency repairs across Gauteng

081 566 5451

Gate motors · Rosebank

Gate motor repairs and installation in Rosebank

A pair of swing gates in Parkhurst that no longer meet in the middle, an old Centurion R5 in Parkwood whose light flashes four times, a new motor for a gate in Craighall Park: we repair and install gate motors across Rosebank and its suburbs.

Our promise

Six-month guarantee on our repairs

Our promise

1-year guarantee on every motor kit we supply and install

Rosebank

Rosebank and the areas around it. Every area we cover

Swing gates on older streets

The houses of Parkhurst, Parkwood, Dunkeld and Craighall Park often stand on stands where there's no room along the wall for a sliding gate to run back, so their gates swing. A swing gate needs space of its own: room on the driveway for the leaves to open inward, hinges that hold the leaves level, and pillars strong enough to take the motor's push. Where a gate opens outward, over the pavement, the motor has to be fitted for that, and Centurion's manual is clear that a motor must never sit on the outside of a gate where the public can reach it.

A technician adjusting the bracket of a gate arm on a brick pillar beside a double swing gate

Centurion's R3 and R5

Older swing gates around Rosebank may be driven by Centurion's R3 or R5, rotary motors that turn the leaf through a pair of articulated arms. From Centurion's installation manual:

  • Battery driven, with a 12 V motor kept charged from the mains, so the gate keeps working in a power cut for about 20 operations on a 7 Ah battery.
  • Two strengths: the R3 at 95 Nm, opening a gate in about 10 seconds, and the R5 at 250 Nm, in about 13.
  • Domestic duty of about 20 operations a day on the standard charger, rising to 100 (R3) or 250 (R5) with a heavy-duty power pack.
  • Sealed to IP55, with the arms protected against corrosion.

We repair both: batteries and chargers, the CP75 control card, the arms and their pivots, and the position sensors.

How heavy a leaf a swing motor can take

A swing motor's limit depends on how long the leaf is as well as how heavy, because a longer leaf puts more load on the arm. Centurion's table for a standard inward-opening installation:

Centurion R3 and R5, largest leaf mass by leaf length
Leaf lengthR3R5
1.5 m400 kg600 kg
2.0 m400 kg600 kg
2.5 m320 kg510 kg
3.0 m225 kg360 kg
3.5 m160 kg260 kg

Wind matters too. Centurion's figures for a 1.8 m high gate show that a fully clad leaf halves the wind speed in which the motor can still open it, compared with an open, mostly see-through one. So a solid timber or clad gate on a windy corner needs the stronger motor, or a lighter gate.

Pedestal or wall mount

The R3 and R5 can stand on a pedestal beside the gate or fix to the pillar:

  • On a pedestal, the motor locks the gate securely without needing end stops, works for inward or outward opening gates and in tight spaces, and gives the smoothest movement. It doesn't depend on the pillar's strength.
  • On the wall, it's compact, but the pillar must be strong enough to carry the motor and the load if someone forces the gate. Fixed square to the pillar, it locks the gate better than fixed parallel.

Either way, Centurion recommends a gate lock on longer leaves: above 3.0 m on a pedestal, or 2.5 m on a wall mount.

A technician fitting a sliding gate motor onto a concrete plinth beside a steel gate

Settings on the CP75 controller

The R-series controller has settings worth choosing deliberately:

  • Mode of operation. Standard (start, stop, reverse), condominium (any trigger opens the gate, and only the timer closes it), PIRAC (it closes as soon as the car has cleared the beams), or reversing (a press reverses the gate, so it can't be left half open).
  • Auto-close, off from the factory, settable from 1 to 255 seconds.
  • Leaf delay, so on a double gate the leaves close in order, which matters where one leaf has a flap that must close against the other.
  • A warning light that flashes before and while the gate moves, and a courtesy light that stays on for 2 minutes after each opening.

When an R3 or R5 won't behave

The controller's status light and the manual's fault guide point to most problems:

  • Three flashes: the battery is low. A gate that moves a short way and stops often has a tired battery.
  • Four flashes: the gate hit something too many times in a row while closing, so the controller ignores triggers for a minute. Clear the obstruction; it resets after 60 seconds.
  • The gate runs past where it should stop: the position sensor has lost its origin, a plug has worked loose, or, as Centurion's manual notes, ants have got under the sensor's dust cover.
  • The gate starts closing, stops and reopens: a false collision, from something like a stiff hinge or a dragging leaf, or the beams cutting in and out.

All our spare parts are genuine, and every repair comes with our six-month guarantee on our repairs. The fault finder below has the checks that are safe to try first.

Measuring how far a gate swings

How far the leaves open decides which motor and which mounting will fit, and installers measure it simply. Centurion's method: mark the ground 1 m from the hinge along the closed gate, and again 1 m from the hinge along the open gate, then measure between the two marks. A gap of about 1,351 to 1,475 mm means the gate opens through 90 degrees; less means a narrower angle, more a wider one.

New gate motors in Rosebank

Our kits are installed at a set price with battery and remotes: the Centurion Vantage 500 double swing kit at R15 799 or the ET Wingo double swing kit at R13 999 for a pair of swing gates, and the Centurion D5-Evo SMART sliding gate kit at R7 999 for a sliding gate. Prices checked October 2026. Your exact price is set in a free quote before any work starts. No call-out fee when we do the work. If no work is done, a R650 call-out fee applies.

  • Swing gate kit

    Centurion Vantage 500 double swing kit

    R15 799incl. installation

    In the kit

    • 2 operators
    • wall box with charger
    • 12 V 7 Ah battery
    • mains isolator
    Our promise

    1-year guarantee on every motor kit we supply and install

  • Swing gate kit

    ET Wingo double swing kit

    R13 999incl. installation

    In the kit

    • 2 operators
    • 2 × 4-button ET remotes
    • 12 V 7 Ah battery
    • wall box with charger
    Our promise

    1-year guarantee on every motor kit we supply and install

  • Sliding gate kit

    Centurion D5-Evo SMART sliding gate kit

    R7 999incl. installation

    In the kit

    • D5-Evo SMART motor (gates up to 500 kg)
    • 12 V 7 Ah battery
    • 2 × 4-button NOVA remotes
    • 4 m steel rack
    Our promise

    1-year guarantee on every motor kit we supply and install

Prices checked October 2026. Price includes the kit listed, standard installation on a gate or door that already runs freely, and our 1-year kit guarantee. Not included: a power point at the motor if there isn't one (a job for a registered electrician), extra rack, gate or door repairs, and accessories. These are quoted before any work starts.

Compare two kits

SpecCenturion Vantage 500 double swing kitET Wingo double swing kit
Price, installedR15 799R13 999
ForSwing gateSwing gate
In the box2 operators2 operators
In the boxwall box with charger2 × 4-button ET remotes
In the box12 V 7 Ah battery12 V 7 Ah battery
In the boxmains isolatorwall box with charger
Guarantee1-year guarantee on every motor kit we supply and install1-year guarantee on every motor kit we supply and install

Booking a gate technician in Rosebank

On the job card, give the motor's make and model if there is one, whether the gate swings or slides, and what it's doing; a photo of the motor helps. We work in Rosebank and around it, in Parkhurst, Parkwood, Dunkeld, Oaklands, Forest Town, Killarney and Craighall Park. Same-day repairs are offered when the day allows, and a gate stuck open is treated as urgent.

Fault finder

What is your gate doing?

Pick what you're seeing for the likely causes, the safe checks you can do yourself, and when to stop and book. Taken from the manufacturers' own manuals.

What's it doing?

Likely causes

Gate motor · it's beeping

Most likely first

  1. The mains power to the motor is off, so it's running on its battery. Centurion and Gemini motors give two beeps (or two flashes) in a row; an ET Drive flashes twice and gives a one-second beep every 15 seconds.

  2. The battery is low. Centurion and Gemini motors give three beeps in a row; an ET Drive's status light flashes four times, without a beep.

  3. Something is between the safety beams. A Centurion motor gives a single beep every so often and won't close.

  4. The gate has hit something several times in a row, so the motor has stopped to protect itself. A Centurion keeps beeping until that's cleared.

  5. A holiday lockout or a time setting is blocking the remote: the motor beeps once when you press it and the gate doesn't move.

  6. On a Gemini, four beeps as the motor starts means the manual release lever isn't fully engaged.

Safe checks you can do

When to stop and book

If it keeps beeping with the power on and the beams clear, the battery, charger or controller needs a technician. Don't open the motor: Centurion warns that work by anyone unauthorised may void the manufacturer's warranty.

Questions

Gate motor questions in Rosebank

Why is my Centurion R5's light flashing four times?

The gate hit something too many times in a row while closing, so the controller ignores triggers for a minute. Clear whatever is in the way; it resets after 60 seconds. Read about R3 and R5 faults.

How heavy a swing gate can a Centurion R3 move?

Up to 400 kg on a leaf of 2 m or less, falling to 160 kg on a 3.5 m leaf; the R5 takes 600 kg down to 260 kg. Clad gates in wind need more. See the table.

Can a swing gate motor be fitted on the outside of the gate?

Not where the public can reach it, Centurion says. An outward-opening gate is set up differently, with the motor still on the property side. Read about swing gates.

Should a swing gate motor go on a pedestal or the pillar?

A pedestal locks the gate without end stops and doesn't rely on the pillar; a wall mount is compact but needs a strong pillar. Compare the two.

Book a technician

Get a gate motor quote in Rosebank

Job card

We WhatsApp or call you back. Fields marked (required) are needed.

Property type
When
Photos (optional, up to 4)

No call-out fee when we do the work. If no work is done, a R650 call-out fee applies.