Electric fences · Rosebank
Electric fence repairs in Rosebank, old energisers and new
A Merlin energiser in Parkhurst that has run for years and now shows a service fault, a fence in Forest Town that alarms when the side gate is left open, a block in Killarney whose perimeter fence needs a new energiser: we repair and install electric fences across Rosebank. 2-year warranty and a compliance certificate on every new electric fence we install.
2-year warranty and a compliance certificate on every new electric fence we install
Six-month guarantee on our repairs
Rosebank and the areas around it. Every area we cover
Older Nemtek energisers: the Merlin Stealth
Nemtek's Merlin Stealth is an older range of energisers than its current Druids, and Merlin units still power fences on older properties. The range has single-zone models, the M15S and M18S, and two-zone models, the M25S and M28S, all running from a 12 V 7 Ah battery kept charged from the mains. From Nemtek's installer manual:
- Output, with the fence disconnected, can be set from about 6,000 to 8,500 V on the M15 and M25, and about 7,000 to 9,300 V on the M18 and M28, which also deliver more energy.
- Earth loop monitoring is built in, so a cut earth wire can raise an alarm, and Nemtek prefers the fence wired that way.
- A diagnostics port lets a technician read what the energiser has been doing.
A Merlin that has been on a wall for years has also been through a great many storms and power cuts, and that's often when we're called to one.

The battery test you never see
A Merlin can be set to test its own battery. At regular intervals it switches the mains off for 20 minutes and watches the battery voltage, with nothing on the display to show it's happening. If the battery sags below the level set by the installer, the energiser gives a service warning. So a service fault that appears overnight, with nothing else wrong, can simply be a battery that failed its test. (Nemtek notes the test doesn't run for the first week after the energiser has been reset to factory settings.)
Separately, the energiser protects the battery by disconnecting it altogether if its voltage drops below a factory-set level in a long power cut, a cut-off the installer can't change. The fence then stays off until the mains returns.
Three fuses, three symptoms
A Merlin Stealth has three fast-blow fuses on its board, and each fails in a way you can recognise:
| Fuse | If it blows |
|---|---|
| Charger, 4 A | The power light goes out even with the mains on; the battery runs flat, a service alarm follows, and the energiser stops |
| Auxiliary, 2 A | The keypad goes dead, and the siren and strobe stop working |
| Battery, 2 A | The energiser switches off the moment the mains fails |
Nemtek's advice is to check what's behind each one before replacing it: the mains supply for the charger fuse, the siren, strobe, keypad and their wiring for the auxiliary fuse, and the battery and its leads for the battery fuse. The fuses sit inside the energiser, alongside the mains connection, so this is our job rather than yours.
Siren timing, and the reset that clears it
How a Merlin's siren behaves is set by the installer, within Nemtek's limits:
- The siren sounds for a set time, anywhere from 2 seconds to 4 minutes 30 seconds.
- Alarms are then ignored for a set alarm-off time.
- After a set number of alarm events, from 1 to 16, the re-arm timer takes over, which can be anything from 20 seconds to about 7.7 days, before the alarm process can repeat.
One detail matters day to day: switching the fence off and on again at the keypad resets every alarm timer and counter. So if the siren has stopped because the re-arm timer has taken over, switching the fence off and on brings the alarms back, and if the fault is still there, the siren with them.
Two gates on one fence
Plenty of houses have two ways in: a driveway gate and a pedestrian gate. A Merlin Stealth has two gate inputs, each with a magnetic switch and its own delay, from 2 seconds to 4 minutes 30 seconds, before a gate left open sets off the alarm. That lets the driveway gate, which a car takes time to clear, have a longer delay than the pedestrian gate, which shouldn't stand open at all.
If your fence alarms whenever a gate opens, even briefly, the delay may be set too short, or the gate's magnetic switch may have shifted out of line; if it never alarms when a gate is left open, the switch may have failed.
An alarm if someone opens the energiser
A Merlin Stealth can raise a tamper alarm when its front lid is taken off while it's running. Nemtek ships it with this off, and it's worth switching on where the energiser hangs somewhere other people can reach, such as an open carport, an outside wall or a block's shared service area. Its remote on/off input can also be set two ways: by default the fence changes state each time the input changes, or it can be set so that one position always means on and the other off, which suits a key switch.
Apartment and office blocks
On Rosebank's blocks, the electric fence usually runs along the top of the perimeter wall, often divided into zones, with the energiser in a service room and the alarm wired to the security company or a guardhouse. It belongs to the body corporate or the building's owner, so we work with the managing agent or the building manager, and arrange access to the service room and the roof or wall where we need it.
Repair or replace an older energiser?
A fault on an older energiser isn't always a reason to replace it. A fuse, a battery, a keypad or a gate switch is a repair. A board damaged by lightning, or an energiser that keeps failing, is often better replaced, and a current Druid adds things a Merlin can't, such as Nemtek's newer display and, on some models, control from a phone. We'll test it and tell you which makes sense, with prices for both.
All our spare parts are genuine, and every repair comes with our six-month guarantee on our repairs. The checks that are safe to try first, without touching the wires or opening the energiser, are in the fault finder below.
New fences and certificates
A new fence, or a new energiser on an old fence, is planned with you on site, built to the rules Nemtek and JVA print in their manuals, tested along its length, and handed over with its certificate. Certified electric fence installer. If you're selling and only need the certificate, see electric fence certificates.
Typical electric fence prices
Market prices in Gauteng, from cost guides, installer price lists and shop listings, not ours:
- Energiser repair: R800–R2 500 (Kandua)
- Complex faults or a new energiser: R1 500–R5 000+ (Kandua)
- Nemtek Druid 18, in shops: about R4 490 (Takealot)
- Nemtek Druid 28 LCD, in shops: about R5 190–R5 210 (Takealot, NeonSales)
- 6-line wall-top fence, installed: R95–R115 a metre (published price lists of Gauteng installers)
Prices checked October 2026. Your exact price is set in a free quote before any work starts. No call-out fee when we do the work. If no work is done, a R650 call-out fee applies.
Booking a fence technician in Rosebank
On the job card, give the energiser's make and model, what the keypad or display shows, and what the fence is doing; for a block, add who will meet us and where the energiser is. We work in Rosebank and around it, in Parkhurst, Parkwood, Dunkeld, Oaklands, Forest Town, Killarney and Craighall Park. Same-day repairs are offered when the day allows, and a fence that's down at night is treated as urgent.
Fault finder
What is your fence doing?
Pick what you're seeing for the likely causes, the safe checks you can do yourself, and when to stop and book. Taken from the manufacturers' own manuals.
What's it doing?
Likely causes
Electric fence · the alarm keeps going off
Most likely first
The fence voltage has dropped below the alarm level: something is touching the wires, or plants have grown into the fence.
The gate input is open: the gate isn't fully closed.
The fence condition is poor: dirty or failed insulators, or wet insulators after rain.
Safe checks you can do
When to stop and book
Never touch the fence wires or open the energiser. If the alarm won't clear, we'll find the fault on the fence.
From the official manuals: Nemtek Druid 25 and 28 user manual, Nemtek Druid LCD user manual.
Questions
Electric fence questions in Rosebank
Why does my Nemtek Merlin show a service fault overnight?
It may have failed its own battery test: at set intervals it turns the mains off for 20 minutes to check the battery, without showing it. A weak battery then raises a service warning. Read about the battery test.
Can an electric fence watch two gates with different delays?
On a Merlin Stealth, yes: it has two gate inputs, each with its own delay from 2 seconds to 4 minutes 30 seconds before an open gate alarms. Read about two gates.
Can my energiser alarm if someone opens it?
A Merlin Stealth can give a tamper alarm when its lid is removed while it runs. It's off from the factory, so it has to be switched on. Read about the tamper alarm.
Should I replace my old Nemtek Merlin energiser?
Not always: a fuse, battery, keypad or gate switch is a repair. A lightning-damaged board, or a unit that keeps failing, is often better replaced. We test and price both. Read about repair or replace.
Book a technician
Get an electric fence quote in Rosebank
Job card
We WhatsApp or call you back. Fields marked (required) are needed.