Skip to content

24/7 emergency repairs across Gauteng

081 566 5451

Intercoms · Rosebank

Intercom repairs in Rosebank, for blocks and houses

A block in Killarney where the top-floor flats can't hear the gate, an office building off Jan Smuts Avenue changing its door entry, a house in Oaklands with a handset that has gone quiet: we repair and install intercoms across Rosebank.

Our promise

Six-month guarantee on our repairs

Rosebank

Rosebank and the areas around it. Every area we cover

Intercoms for apartment and office blocks

A block's entrance has to reach every flat or office behind it, and there are three ways to do it:

  • Wired door entry: a panel at the entrance with a button or code per unit, cabled to a handset or screen in each. Reliable, but every unit needs its cable, which is hard to add in a finished building.
  • Wireless multi-unit: a gate station that calls each unit's handsets by radio, such as Zartek's CDP-808, with no cable to the units at all.
  • GSM: an entrance unit that phones residents' cellphones, so nothing is needed inside the flats.

Which suits a block depends on its size, how it's built, and whether cable can reach the units. We look at the building before recommending one.

A hand entering a code on a steel keypad pedestal beside a driveway gate

How a wireless block intercom is set up

The order of work in Zartek's installer manual for the CDP-808 is what makes these systems reliable, because it proves the radio range before anything is fixed to a wall:

  1. Charge the gate station and every handset for at least 2 hours.
  2. Programme a first code on a table, not out at the gate, and pair a handset to it.
  3. Mount the antenna temporarily at the entrance, and test from the furthest unit, inside the unit itself, with a real call and a real gate opening.
  4. Raise the antenna if the range falls short, and test again.
  5. Programme every name and unit code, once the range is proven, and pair each unit's handsets together.
  6. Test each handset, then mount the gate station and antenna for good, connect the power and the gate motor, and test every unit one last time.

Skipping step 3 is how a block can end up with a top floor that can't hear the gate.

Range inside buildings

Zartek gives the CDP-808 a range of about 100 m among buildings and 350 m over open ground, and says it depends on the terrain. Buildings are hard terrain for radio: concrete floors, brick walls, basements and steel all weaken a radio signal, so the flats furthest from the entrance, or below it, are the first to struggle. The remedies, in order:

  • The gate station's external antenna, mounted as high as it can go.
  • Handsets with an external antenna, which Zartek offers for the longest reach.
  • A different channel, if the trouble is interference rather than distance. There are four, and every handset must be on the same one as the gate station.

If a building is simply too much for radio, a wired or GSM system is the honest answer, and we'll say so.

Power for the gate station

Zartek is firm that the gate station runs only from the 12 V switching supply it comes with, which gives a steadier voltage than an ordinary adapter, and not from anything else, including a 12 V battery back-up system. It has its own lithium battery, which carries it through about 4 to 5 hours of a power cut in normal use. If a gate station is taken down and stored, its battery should be unplugged, or it runs flat.

Wired door entry in older blocks

Older blocks may have a wired system that has been extended and repaired over the years, with cable running through risers and ceilings to every flat. When part of it fails, the pattern points to the cause: one silent flat is that flat's handset or its cable; the whole block silent is the entrance panel or its power supply. Where the cable through the building has failed in several places, replacing it with a wireless or GSM system can cost less than rewiring, and disrupts residents far less.

Houses around Rosebank

In Parkhurst, Parkwood, Dunkeld, Oaklands, Forest Town and Craighall Park, the intercom is a household one: a wired set with a handset in the kitchen, a wireless set for a long driveway, or a video intercom at the pedestrian gate. We repair all of them, and fit the link that lets the handset open the gate.

Intercom repairs in Rosebank

We repair Zartek, Centurion, Commax, Kocom and BPT intercoms: entrance panels and gate stations, handsets and screens, aerials, power supplies, cables and joints, and the links to gates and door locks. All our spare parts are genuine, and every repair comes with our six-month guarantee on our repairs. The fault finder below has the checks that are safe to try first.

Typical intercom prices

Market prices in Gauteng, from cost guides, installer price lists and shop listings, not ours:

  • Basic audio intercom, installed: R2 500–R5 000 (Kandua)
  • Video intercom, installed: R5 000–R15 000+ (Kandua)
  • GSM gate module, installed: R1 500–R3 000 (published price lists of Gauteng installers)
  • Dahua 4-wire video kit, in shops: about R2 190 (Takealot)
  • Nice 7-inch colour video kit, in shops: about R3 000 (Takealot)

Prices checked October 2026. Your exact price is set in a free quote before any work starts. No call-out fee when we do the work. If no work is done, a R650 call-out fee applies.

Booking an intercom technician in Rosebank

On the job card, say whether it's a house or a block, give the intercom's make if you know it, and describe which units are affected; for a block, add who will meet us. We work in Rosebank and Killarney and in the suburbs around them: Parkwood, Parkhurst, Dunkeld, Oaklands, Forest Town and Craighall Park. Same-day repairs are offered when the day allows, and an intercom that has stopped opening the entrance is treated as urgent.

Fault finder

What is your intercom doing?

Pick what you're seeing for the likely causes, the safe checks you can do yourself, and when to stop and book. Taken from the manufacturers' own manuals.

What's it doing?

Likely causes

Intercom · the handset can't reach the gate unit

Most likely first

  1. No power to the gate (caller) unit.

  2. The handset's battery has run down.

  3. Too far apart, or a lot of steel in between.

  4. The handset and gate unit have lost their pairing.

Safe checks you can do

When to stop and book

Re-pairing a system or moving a unit for better range is a quick job on the visit.

Questions

Intercom questions in Rosebank

Will a wireless intercom reach flats on every floor?

Often, but concrete floors and basements cut radio range, so it's proven before anything is fixed: the antenna is mounted temporarily and tested from the furthest flat. Read about range.

Can a wireless gate station run from our battery back-up system?

Zartek says no: the CDP-808 gate station runs only from its own 12 V switching supply, and has its own lithium battery for 4 to 5 hours of a power cut. Read about power.

How is a wireless block intercom tested before it's installed?

One code is programmed and paired, the antenna is mounted temporarily, and a real call and gate opening are tested from the furthest unit before the rest is set up. Read how it's set up.

Why does our block's intercom work on some floors but not others?

On a wireless system, the far floors are often at the edge of its range; a higher antenna or handsets with their own antenna can help. On a wired one, look at the cable to those floors. Read about range.

Book a technician

Get an intercom quote in Rosebank

Job card

We WhatsApp or call you back. Fields marked (required) are needed.

Property type
When
Photos (optional, up to 4)

No call-out fee when we do the work. If no work is done, a R650 call-out fee applies.