Skip to content

24/7 emergency repairs across Gauteng

081 566 5451

Electric fences · Centurion

Electric fence repair and installation in Centurion

A Nemtek energiser in Eldoraigne with a light that keeps flashing, a fence in Rooihuiskraal that alarms whenever the gate is left open, a new fence for a house in Irene: we repair and install electric fences across Centurion. 2-year warranty and a compliance certificate on every new electric fence we install.

Our promise

2-year warranty and a compliance certificate on every new electric fence we install

Our promise

Six-month guarantee on our repairs

Centurion

Centurion and the areas around it. Every area we cover

Nemtek's Wizord energisers

Centurion searches for Nemtek by name, and Nemtek's Wizord 2 and Wizord 4 are a straightforward pair worth knowing. Each is an energiser, a battery charger and a fence monitor in one weatherproof box, with outputs for a siren and a strobe light. Nemtek builds in protection against lightning and power surges on both the mains and the fence side. Other features from Nemtek's manual:

  • A gate input with an entry delay: four minutes, one minute on the Wizord 2, or an immediate alarm.
  • High and low voltage modes, switchable on the Wizord 2.
  • Earth loop monitoring, an extra security check on the fence's earth.
  • A connection for an armed response radio, so an alarm goes straight to the response company.
  • A 12 V auxiliary output of up to 0.5 A, for a small device such as a radio receiver.

The other Nemtek ranges, and JVA's, are compared on our energiser page.

A technician shining a torch on the terminals of an open electric fence energiser box in a garage

What the fence does in a power cut

When the mains goes off, a Wizord doesn't simply run on as before: it drops the fence to a lower energy level so the battery lasts. Nemtek puts a new, fully charged battery at typically more than 24 hours, depending on the state of the fence. Two things follow from that:

  1. The fence display may not be fully lit during a power cut. That's the lower energy level, not necessarily a fault, so Nemtek's advice is to let the mains come back before judging the fence.
  2. The battery is doing real work through every outage. Nemtek asks for batteries to be checked twice a year, and a battery that no longer covers a night of load-shedding is due for replacement.

The batteries are lead-acid, which need venting, so the energiser belongs somewhere well ventilated, never sealed in a cupboard. If a fault light stays on after a long power cut, Nemtek's first step is simply to switch the energiser off and on again; if it persists, it's a job for us.

Reading the lights on a Wizord

The Wizord's lights tell you most of what's happening:

  • An alarm light flashing: the problem is still there, for example the fence voltage is still too low, or the gate is still open.
  • An alarm light lit steadily: there was an alarm, but the condition has since cleared.
  • The power light off: the mains has failed and it's running on the battery.
  • The On light flashing: the fence is in low voltage mode.
  • The service light flashing after a long outage: the battery is running low.

To reset an alarm, switch the unit off with the Nemtek tab or the remote key-switch, which silences the siren and buzzer. Switching it back on clears a steady light. A flashing light means the cause needs fixing first, and that's where we come in. The buzzer even uses a different rhythm for a fence alarm and a gate alarm.

A hand entering a code on a steel keypad pedestal beside a driveway gate

The gate, the motor and the fence

Most fences in Centurion meet a motorised gate, and that's where a lot of false alarms begin. The energiser's gate input watches whether the gate is shut, and once the entry delay runs out with the gate still open, it alarms. A gate left open by a visitor or a delivery is enough.

The gate motor can prevent that. Centurion's D5-Evo and D10 can close the gate on their own a set time after it opens, but only with safety beams fitted across the entrance, so it can never close on a car or a person. Set to close well inside the fence's entry delay, the gate stops tripping the alarm. And if you have Centurion's G-SPEAK ULTRA intercom, it can be wired to the energiser to message you when the fence is armed or alarms.

Because we work on both, we set up the gate contact, the motor's auto-close and the beams together. See Centurion gate motors in Centurion.

Electric fence repairs in Centurion

We test the fence zone by zone and repair what we find:

  • Storm damage: an energiser, keypad or gate contact knocked out by a surge in the summer storm season, or insulators cracked by a strike nearby.
  • A broken earth: the earth wire or spikes damaged by digging or paving, which can make the fence weak and the alarms unreliable.
  • Wire broken, slack or touching a bracket.
  • Plants growing into the lines, which Nemtek's manual asks owners to keep clear.
  • Gate contacts out of line, so a closed gate still reads as open.
  • Batteries past their best.

All our spare parts are genuine, and every repair comes with our six-month guarantee on our repairs. The safe checks to try first are in the fault finder below; never touch the fence or open the energiser, which has no parts an owner can service.

Between visits

Nemtek's own list for owners is short, and all of it can be done from a safe distance: keep plants and branches trimmed back from the lines, look along the fence now and then for strands that have gone slack or come off a bracket, and have the battery tested twice a year. Add one more for Centurion's summers: after a big storm, check that the energiser's lights look as they normally do, because a surge can leave a fence quietly off. Look, don't touch, and call us for anything on the fence itself.

New electric fences in Centurion

A new fence begins with a walk of the boundary to agree the lines, the zones, where the energiser and keypad go, and where the earth spikes can be driven well away from other earth systems. It's then built to the requirements Nemtek and JVA print in their manuals: warning signs at the gates and along the fence, no barbed or razor wire near the live lines, and gates that open without anyone touching a live wire. Certified electric fence installer, so the fence is handed over with its certificate. Where a fence will sit on palisade or mesh, see steel fencing and electric fence installers in Centurion, and the steps are on electric fence installation.

A technician on a ladder holding a fence tester against the strands of an electric fence on a boundary wall

Certificates for a sale

A property with an electric fence needs an Electric Fence System Certificate when it's sold. We inspect the fence and issue one when it complies; when it doesn't, we price the work it needs. More on electric fence certificates.

Typical electric fence costs in Gauteng

Market prices from cost guides and installer price lists, not ours:

  • Wall-top, 6–8 lines fence, installed: R100–R170 a metre (Kandua)
  • Typical suburban home, 50–100 m wall-top fence with certificate: R12 000–R25 000 (Kandua)
  • Simple repairs (insulators, a broken wire) including call-out: R700–R1 400 (Kandua)
  • Energiser repair: R800–R2 500 (Kandua)
  • 12 V 7 Ah battery, in shops: R230–R450 (Takealot)
  • Gauteng inspection fee: R900–R1 800 (Kandua)

Prices checked October 2026. Your exact price is set in a free quote before any work starts. No call-out fee when we do the work. If no work is done, a R650 call-out fee applies.

Booking a fence technician in Centurion

Tell us on the job card which energiser you have, which lights are on or flashing, and whether the gate is involved. We work across Centurion, from Lyttelton, Clubview and Kloofsig to Eldoraigne, Wierda Park, Rooihuiskraal and Irene. Same-day repairs are offered when the day's bookings allow, and a fence that has had to be switched off counts as urgent.

Fault finder

What is your fence doing?

Pick what you're seeing for the likely causes, the safe checks you can do yourself, and when to stop and book. Taken from the manufacturers' own manuals.

What's it doing?

Likely causes

Electric fence · the alarm keeps going off

Most likely first

  1. The fence voltage has dropped below the alarm level: something is touching the wires, or plants have grown into the fence.

  2. The gate input is open: the gate isn't fully closed.

  3. The fence condition is poor: dirty or failed insulators, or wet insulators after rain.

Safe checks you can do

When to stop and book

Never touch the fence wires or open the energiser. If the alarm won't clear, we'll find the fault on the fence.

Questions

Electric fence questions in Centurion

Why is the light on my Nemtek energiser flashing?

On a Wizord, a flashing alarm light means the problem is still there, such as low fence voltage or an open gate; a steady one means it has cleared. A flashing On light means low voltage mode. Read about the lights.

Why does my fence alarm when the gate is left open?

The energiser's gate input alarms once its entry delay runs out with the gate still open. A gate motor set to close on its own, with safety beams fitted, prevents it. Read about the gate and the fence.

How long will my electric fence run in load-shedding?

Nemtek puts a new, fully charged battery at typically more than 24 hours on a Wizord, which drops to a lower energy level to save power. An older battery manages less. Read about power cuts.

Do you repair Nemtek energisers in Centurion?

Yes, the Wizord and Druid ranges and older Nemtek units, as well as JVA energisers, including surge and storm damage. See fence repairs.

Book a technician

Get an electric fence quote in Centurion

Job card

We WhatsApp or call you back. Fields marked (required) are needed.

Property type
When
Photos (optional, up to 4)

No call-out fee when we do the work. If no work is done, a R650 call-out fee applies.