Skip to content

24/7 emergency repairs across Gauteng

081 566 5451

Intercoms · Centurion

Centurion intercom systems in Centurion, installed and repaired

A G-SPEAK ULTRA in Zwartkop that has stopped calling, a house in Lyttelton whose wired handsets ring in the house but not the cottage, an older Polophone in Clubview that has gone quiet: we install and repair Centurion's intercoms, and other makes, across Centurion.

Our promise

Six-month guarantee on our repairs

Emergency

24/7 emergency repairs across Gauteng

Centurion

Centurion and the areas around it. Every area we cover

Centurion's intercoms, from handset to GSM

Centurion, the gate motor maker, makes intercoms too, which can draw their power from its gate motors. Two families cover most homes:

  • The wired Intercom Handset system: a gate panel and handsets in the house, joined by cable, for when you want to answer from the kitchen or the bedroom.
  • The G-SPEAK range: GSM intercoms with a SIM card that call your cellphone, for when you want to answer from anywhere. The current model is the G-SPEAK ULTRA.

We also repair Centurion's older Polophone intercoms. If you were looking for a Polophone manual, we don't publish one, but we can usually tell what's wrong from what the unit does, and whether a repair or a replacement makes more sense. We install and repair Commax, Kocom, BPT and Zartek intercoms as well.

A woman answering a white wall-mounted intercom handset in her kitchen

The wired Intercom Handset system

Centurion's wired audio system grows from a simple one-to-one kit to a system of up to five parts:

  • Up to two entry panels, for example one at the vehicle gate and one at a pedestrian gate.
  • Two groups of handsets, with up to three handsets in each.
  • Each call button rings one group or both, depending on how it's set, and the two groups can talk to each other. On a property with a main house and a cottage, that means the gate can ring either or both, and the house can call the cottage.

The entry panel is sealed against dust and water jets (IP56), and the system has surge protection. It can run from the gate motor's own DC supply or a separate 14 V supply, and the handset's trigger buttons open the gate; a gate status light shows whether it's open. A pedestrian gate's electric lock needs a power supply of its own, wired through the intercom's contact.

The G-SPEAK ULTRA, set up properly

The G-SPEAK ULTRA is two parts: a gate station at the gate and a controller, usually inside the gate motor's housing, that holds the SIM and runs on 11 to 24 V DC from the motor. It uses the 4G network wherever it can, falling back to 2G, and takes a nano-SIM or, in South Africa, an e-SIM. The kits pair it with a gate station:

  • A metal gate station with one, two or four call buttons, sealed to IP54 when it's mounted properly (on a gooseneck, with Centurion's backing plate).
  • A plastic gate station with two buttons, sealed to IP52.

The controller itself is only IP40, which is why it belongs inside the motor's housing or another cover, never exposed. It has four channels, each an input or an output; by default all four are outputs for the gate, a pedestrian gate and so on, and the fourth can instead report whether the gate is open.

Setting it up is done through Centurion's G-WEB and its apps: the numbers the gate station calls, who may open the gate, time limits for visitors, and messages from the unit. We install it, wire it into the motor, set up the numbers and access with you, and test a call before we leave.

A technician wiring the back of a gate intercom keypad on a steel pedestal at a driveway

When a G-SPEAK ULTRA stops working

The controller has a small screen that shows most of what matters: the network it's on, the signal strength, whether it's connected to G-WEB, SMSs in and out, the state of each output, the SMS credits left, and whether the SIM's PIN was accepted. Most faults show up there.

  • No signal, or a weak one: the antenna, the network at the gate, or a SIM problem.
  • SIM PIN incorrect: the SIM has a PIN the unit doesn't know.
  • Not connected to G-WEB: the settings can't sync. The Device Reset menu has a Re-sync, which refreshes the connection to G-WEB without erasing anything.
  • Out of SMS credits or airtime: calls and messages stop until it's topped up.

The same menu has a Factory Reset, which wipes every setting back to new, and works only while the unit is connected to G-WEB. It isn't a step to try on a hunch; call us first.

Intercom repairs in Centurion

Beyond the G-SPEAK, these are the intercom faults we fix most:

  • A handset that rings but can't be heard, or a gate panel with a crackle after rain.
  • Handsets that ring in one building but not the other, usually the group setting or the cable between them.
  • A trigger button that no longer opens the gate, from the wiring to the motor or the motor itself.
  • Dead after a storm, when a surge has reached the power supply.

All our spare parts are genuine, and every repair comes with our six-month guarantee on our repairs. The fault finder below has the checks that are safe to do first.

What intercoms typically cost

Typical market prices from installer price lists and cost guides, not ours:

  • GSM gate module, installed: R1 500–R3 000 (published price lists of Gauteng installers)
  • Basic audio intercom, installed: R2 500–R5 000 (Kandua)
  • Intercom added during a gate motor installation: R2 000–R5 000 (published price lists of Gauteng installers)

A GSM unit also needs airtime or SMS credits on its SIM. Prices checked October 2026. Your exact price is set in a free quote before any work starts. No call-out fee when we do the work. If no work is done, a R650 call-out fee applies.

Booking an intercom technician in Centurion

On the job card, give the intercom's make and model, what happens when a visitor presses the button, and for a G-SPEAK, what its screen shows. We work across Centurion, from Lyttelton, Clubview and Zwartkop to Eldoraigne, Wierda Park, Heuwelsig and Irene. Same-day repairs are on offer when the day's bookings leave room. For the motor behind the intercom, see Centurion gate motors in Centurion.

Fault finder

What is your intercom doing?

Pick what you're seeing for the likely causes, the safe checks you can do yourself, and when to stop and book. Taken from the manufacturers' own manuals.

What's it doing?

Likely causes

Intercom · the handset can't reach the gate unit

Most likely first

  1. No power to the gate (caller) unit.

  2. The handset's battery has run down.

  3. Too far apart, or a lot of steel in between.

  4. The handset and gate unit have lost their pairing.

Safe checks you can do

When to stop and book

Re-pairing a system or moving a unit for better range is a quick job on the visit.

Questions

Intercom questions in Centurion

Can a Centurion intercom ring both the house and the cottage?

Yes. Centurion's wired Intercom Handset system has two groups of up to three handsets; each call button rings one group or both, and the two groups can talk to each other. Read about the handset system.

Does the G-SPEAK ULTRA work on 4G?

Yes, it uses 4G wherever it can and falls back to 2G, and takes a nano-SIM or, in South Africa, an e-SIM. Read about the G-SPEAK ULTRA.

What does Re-sync do on a G-SPEAK ULTRA?

It refreshes the unit's connection to Centurion's G-WEB without erasing any settings. A Factory Reset is different: it wipes everything. Read about the screen and resets.

Do you repair old Centurion Polophone intercoms?

Yes. We find the fault from what the unit does and tell you whether a repair or a replacement makes more sense. Read about Centurion's intercoms.

Book a technician

Get an intercom quote in Centurion

Job card

We WhatsApp or call you back. Fields marked (required) are needed.

Property type
When
Photos (optional, up to 4)

No call-out fee when we do the work. If no work is done, a R650 call-out fee applies.