Skip to content

24/7 emergency repairs across Gauteng

081 566 5451

Gate motors · Morningside

Gate motor repairs in Morningside, and Gemini's swing gate opener

A pair of swing gates that wedge against each other, a gate that opens in the night with nobody near it, a post-mounted motor that hasn't been opened in years: we repair and install gate motors across Morningside.

Our promise

Six-month guarantee on our repairs

Our promise

1-year guarantee on every motor kit we supply and install

Morningside

Morningside and the areas around it. Every area we cover

A swing motor on a post

Gemini's 24 V DC swing gate opener works differently from the rams and arms seen on many swing gates. Each motor sits in a rust-resistant carrier box on its own steel post, set in concrete beside the gate. The motor turns a crank arm, and a connecting arm runs from the crank to a bracket welded to the gate. One motor, the master, drives a single gate; a pair of gates adds a slave motor for the second leaf.

From Gemini's manual:

Gemini 24 V DC swing gate opener, from Gemini's manual
Speed10 seconds for 90°
Duty cycle65%
MassAbout 26 kg
Limit switchesSeparate for opening and closing
In a power cutRuns from its batteries
ExtrasElectric lock and courtesy light outputs, 12 V for a receiver or beams
RemotesUp to 30
A technician adjusting the bracket of a gate arm on a brick pillar beside a double swing gate

How it's set up

Gemini's installation steps explain most of what goes wrong later:

  • The post goes in the right place. Its flange stands at least 300 mm above the ground, and the clearance Gemini calls "C" must not fall below 150 mm.
  • The arm's reach matches at both ends. The gate bracket is placed so the distance from the bracket to the end of the crank arm is the same with the gate closed and open; only then is the connecting arm cut and welded, and the crank locked.
  • The limits. The closing limit isn't adjustable; if the arm was mounted correctly, it doesn't need to be. The opening limit is set by turning a cam on the worm wheel inside.
  • Two leaves, in order. With a magnetic lock fitted, a setting makes the slave leaf open first and close last, so the two leaves never wedge against each other.

A gate that stops short, overshoots or jams against its partner almost always points to one of these.

What it can do

  • Pedestrian opening. A separate button opens the gate for someone on foot, then closes it again after 10 seconds. On a pair of gates, only the master leaf opens.
  • Auto close, with its delay set on the control card.
  • A courtesy light, switched on when the gate opens and off about three minutes after it closes. The motor's relay only switches the light; it doesn't power it.
  • An electric lock, driven from the control card.
  • Safety beams and a loop detector can be connected to it.

When the gate opens by itself

A gate that opens with nobody near it is unnerving. Gemini's troubleshooting table gives three causes:

  1. Faulty push button wiring, where a damaged cable to a wall button shorts and triggers the gate.
  2. A faulty receiver on the control card.
  3. Someone else's remote learnt into your gate. A neighbour's remote, or one from a previous owner or a former employee, still opens it.

The third is easy to rule out: Gemini's receiver can erase every remote it has learnt, after which you relearn only the ones you hold. After moving into a house, it's worth doing whether or not the gate misbehaves.

Other faults, from Gemini's table

  • The motor doesn't run at all: the power is off, or the battery is disconnected or needs charging.
  • It works from the wall button but not the remote: the remote isn't learnt, its battery is flat, or the remote has failed.
  • It opens a short way, then closes again: something is in the gate's way.
  • It turns the wrong way: the motor direction setting needs changing.
  • Poor range: a flat remote battery, or something blocking the receiver.
  • The gate moves with difficulty: the hinges need lubricating or replacing.

The safe checks, such as the remote's battery and whether something is in the gate's path, are in the fault finder below; anything inside the motor is for us.

Six-monthly care

Gemini calls its opener practically maintenance-free, but asks for a little every six months: the lid off, the main gear greased, and the dust and dirt blown out with low-pressure air. We do it with the power off and the batteries disconnected, and check the arms, brackets, hinges and batteries while the lid is off.

Gate motor repairs in Morningside

We repair Gemini, Centurion and ET motors, swing and sliding: control cards, batteries and chargers, crank and connecting arms, limit switches, receivers, beams and the gates themselves. All our spare parts are genuine, and every repair comes with our six-month guarantee on our repairs.

New gate motors in Morningside

Our set-price kits come with battery back-up and remotes: for swing gates, the ET Wingo double swing kit at R13 999 or the Centurion Vantage 500 double swing kit at R15 799; for a sliding gate, the Gemini 12 V DC slider kit at R6 999. Heavy or unusual gates are quoted on site. Prices checked October 2026. Your exact price is set in a free quote before any work starts. No call-out fee when we do the work. If no work is done, a R650 call-out fee applies.

  • Swing gate kit

    ET Wingo double swing kit

    R13 999incl. installation

    In the kit

    • 2 operators
    • 2 × 4-button ET remotes
    • 12 V 7 Ah battery
    • wall box with charger
    Our promise

    1-year guarantee on every motor kit we supply and install

  • Swing gate kit

    Centurion Vantage 500 double swing kit

    R15 799incl. installation

    In the kit

    • 2 operators
    • wall box with charger
    • 12 V 7 Ah battery
    • mains isolator
    Our promise

    1-year guarantee on every motor kit we supply and install

  • Sliding gate kit

    Gemini 12 V DC slider kit

    R6 999incl. installation

    In the kit

    • Gemini DC slider (gates up to 500 kg)
    • 2 × 3-button Gemini remotes
    • 12 V 7 Ah battery
    • 4 m steel rack
    Our promise

    1-year guarantee on every motor kit we supply and install

Prices checked October 2026. Price includes the kit listed, standard installation on a gate or door that already runs freely, and our 1-year kit guarantee. Not included: a power point at the motor if there isn't one (a job for a registered electrician), extra rack, gate or door repairs, and accessories. These are quoted before any work starts.

Compare two kits

SpecET Wingo double swing kitCenturion Vantage 500 double swing kit
Price, installedR13 999R15 799
ForSwing gateSwing gate
In the box2 operators2 operators
In the box2 × 4-button ET remoteswall box with charger
In the box12 V 7 Ah battery12 V 7 Ah battery
In the boxwall box with chargermains isolator
Guarantee1-year guarantee on every motor kit we supply and install1-year guarantee on every motor kit we supply and install

Booking a gate technician in Morningside

On the job card, say whether the gate swings or slides, the motor's make, and what it's doing; for a swing gate, a photo of the motor and its arm helps. Morningside is a large suburb, 15,723 residents on 6.24 square kilometres at the 2011 census, and we cover all of it, out to Morningside Manor, Edenburg and Sunset Acres. Same-day repairs are offered when the day allows, and a gate stuck open is treated as urgent.

Fault finder

What is your gate doing?

Pick what you're seeing for the likely causes, the safe checks you can do yourself, and when to stop and book. Taken from the manufacturers' own manuals.

What's it doing?

Likely causes

Gate motor · it's beeping

Most likely first

  1. The mains power to the motor is off, so it's running on its battery. Centurion and Gemini motors give two beeps (or two flashes) in a row; an ET Drive flashes twice and gives a one-second beep every 15 seconds.

  2. The battery is low. Centurion and Gemini motors give three beeps in a row; an ET Drive's status light flashes four times, without a beep.

  3. Something is between the safety beams. A Centurion motor gives a single beep every so often and won't close.

  4. The gate has hit something several times in a row, so the motor has stopped to protect itself. A Centurion keeps beeping until that's cleared.

  5. A holiday lockout or a time setting is blocking the remote: the motor beeps once when you press it and the gate doesn't move.

  6. On a Gemini, four beeps as the motor starts means the manual release lever isn't fully engaged.

Safe checks you can do

When to stop and book

If it keeps beeping with the power on and the beams clear, the battery, charger or controller needs a technician. Don't open the motor: Centurion warns that work by anyone unauthorised may void the manufacturer's warranty.

Questions

Gate motor questions in Morningside

Why would my swing gate open in the night with nobody near it?

Gemini's table gives three causes: damaged wiring to a wall button, a faulty receiver, or someone else's remote learnt into your gate. Erasing and relearning your remotes rules out the last. Read more.

Why do my swing gates wedge against each other?

The leaves must move in order: on a Gemini swing opener with a magnetic lock, the slave leaf opens first and closes last. Read about setting it up.

How long does a Gemini swing gate take to open?

About 10 seconds to swing through 90°, by Gemini's figures. See the specifications.

How often should a swing gate motor be serviced?

Gemini asks for its swing opener to be opened every six months, its main gear greased and its dust blown out. Read about care.

Book a technician

Get a gate motor quote in Morningside

Job card

We WhatsApp or call you back. Fields marked (required) are needed.

Property type
When
Photos (optional, up to 4)

No call-out fee when we do the work. If no work is done, a R650 call-out fee applies.