Skip to content

24/7 emergency repairs across Gauteng

081 566 5451

Palisade and weld mesh · Edenvale

Palisade fencing in Edenvale, and weld mesh

Fencing contractors for the whole of Edenvale: palisade on a renovated house in Eastleigh, weld mesh round a cluster in Illiondale, a high-security perimeter for a factory in the industrial suburbs, with gates to match and repairs to fences that have been hit, cut or rusted.

Our promise

Six-month guarantee on our repairs

Edenvale

Edenvale and the areas around it. Every area we cover

Steel fencing for Edenvale homes

Many of Edenvale's older homes in Eastleigh and Illiondale are being renovated, and a new front boundary can be part of the job. Steel fencing suits it: it's see-through, so nobody can work unseen at the gate, it lets light into the garden, and it's quick to put up compared with a wall.

  • Palisade: vertical pressed-steel pales with pointed tops on rails between posts. The strongest of the steel fences and the most obvious deterrent.
  • ClearVu-type mesh: rigid panels with openings too small for fingers, very hard to climb, and almost invisible from across the street.
  • Weld mesh: a welded wire grid, in panels or rolls, for the less exposed sides and back of a property at a lower cost per metre.

Heights run from a low fence that marks the boundary to one above head height that keeps people out. Galvanising protects the steel; a black or charcoal powder coat finishes it.

A new black steel palisade fence and sliding gate along a suburban property

Clusters and townhouse complexes

The clusters of the Avenues and the townhouse complexes across Edenvale fence one perimeter for many homes. A sensible approach is to spend where it shows: palisade or ClearVu-type mesh along the street and at the entrance, weld mesh on the sides and back where the boundary meets neighbours. The body corporate or managing agent usually books the work, and an estate's rules may set the height and colour, so check those first.

The entrance gates, the gate motor, the safety beams and the intercom are best planned with the fence, so posts, motor bases and cables go in once. We install all of them.

Factories and yards in the industrial suburbs

Edenvale's industrial suburbs, Sebenza among them, need fencing that stops people and stands up to trucks: tall palisade or ClearVu-type mesh on deep posts, wide sliding gates for deliveries, a pedestrian gate for staff, and often an electric fence along the top. Very long runs on the back of a site can use weld mesh to keep the cost down. For the electric fence part, see electric fences in Edenvale.

Technicians installing tall mesh security fence panels along a boundary

Gates to match

Driveway and pedestrian gates are made in the same palisade or mesh as the fence and hung by us. A driveway gate that will be automated is built for its motor: a straight bottom rail for the rack on a sliding gate, posts strong enough for the arms on a swing gate. A steel pedestrian gate typically costs R2 500–R6 000 (Completo) in the market (prices checked October 2026). For the motor, see gate motors in Edenvale; for everything else we do in the area, including the electric fencing people often search for alongside palisade, see our Edenvale page.

How a fence goes in

  1. Mark and confirm the line, with any slope, pillars and buried services noted before digging.
  2. Set the posts in concrete at the panel or rail spacing and let them cure.
  3. Fit the fence: rails and pales, clamped panels, or tensioned mesh rolls.
  4. Hang the gates and check they swing or slide freely and latch.
  5. Touch up every cut and drill hole so bare steel doesn't rust.

On a slope, the fence either follows the ground or steps down in even steps, and the bottom is kept close to the ground so dogs stay in.

Fence repairs

A car reversing into a post, a pale cut out to get in, a mesh panel bent or its clamps stolen, rust where sprinklers hit the base, or a gate that has started to drag: we repair the damaged section to match the rest, so one bad stretch doesn't mean a new fence. Six-month guarantee on our repairs.

What steel fencing typically costs

Typical market prices in Gauteng, supplied and installed, not ours:

  • 1.2 m palisade: R900–R1 500 a metre (Kandua)
  • 1.8 m palisade: R1 800–R2 200 a metre (Kandua); R1 980–R2 420 a metre (LocalPros)
  • ClearVu-type high-security mesh: R1 300–R1 600 a metre (ProCompare); R1 200–R1 700 a metre (Completo)
  • weld mesh: R600–R800 a metre (ProCompare)
  • labour only, palisade: R250–R700 a metre (Kandua)

Prices checked October 2026. Your exact price is set in a free quote before any work starts. No call-out fee when we do the work. If no work is done, a R650 call-out fee applies.

Booking a fencing quote in Edenvale

On the job card, give the rough length of the boundary, the kind of fence you want, where the gates go and whether an electric fence will go on top. Photos along the line help us quote close to the final figure. We work across Edenvale, from Eastleigh and Illiondale to Hurlyvale, Sunnyridge and Croydon. Same-day repairs are part of the normal week here for fence and gate damage, whenever the day's bookings allow.

Questions

Fencing questions in Edenvale

Are you fencing contractors in Eastleigh?

Yes, Eastleigh is part of our Edenvale area. We supply and install palisade, ClearVu-type and weld mesh fencing, hang matching gates, and repair damaged fences across Edenvale. Read about fencing for homes.

Is palisade or weld mesh better for a cluster?

Both, in different places: palisade or ClearVu-type mesh on the street front and entrance, where it's seen and tested most, and weld mesh on the sides and back to keep the cost down. Read about clusters.

Can you fence a factory in Edenvale?

Yes. Industrial sites need tall palisade or ClearVu-type mesh on deep posts, wide sliding gates for trucks and often an electric fence on top. Read about industrial fencing.

How much is palisade fencing per metre in Edenvale?

Published cost guides put 1.2 m palisade at R900–R1 500 a metre and 1.8 m at R1 800–R2 200 a metre; R1 980–R2 420 a metre supplied and installed (prices checked October 2026). Gates, pillars and slopes change the total. See typical prices.

Book a technician

Get a palisade fencing quote in Edenvale

Job card

We WhatsApp or call you back. Fields marked (required) are needed.

Property type
When
Photos (optional, up to 4)

No call-out fee when we do the work. If no work is done, a R650 call-out fee applies.