Skip to content

24/7 emergency repairs across Gauteng

081 566 5451

Palisade and weld mesh · Benoni

Steel palisade fencing in Benoni, with ClearVu-type and weld mesh

We supply and install steel fencing across Benoni: palisade on a street front in Northmead, see-through ClearVu-type mesh around a complex in Lakefield, weld mesh along a long boundary near Rynfield, and fencing for business premises in the industrial south. We fit the gates to match and repair what has been hit, cut or rusted.

Our promise

Six-month guarantee on our repairs

Benoni

Benoni and the areas around it. Every area we cover

Palisade, ClearVu-type or weld mesh in Benoni

Benoni's boundaries are varied enough that all three steel fences have their place, and many properties use more than one:

  • Palisade, vertical steel pales with pointed tops bolted to rails, is the strongest and the most obvious deterrent. It suits street fronts, entrances and anywhere a vehicle could be driven at the fence.
  • ClearVu-type high-security mesh, rigid panels with openings too narrow for fingers or toes, is very hard to climb or cut and still looks almost transparent from the street. It suits complexes, schools and homes that want security without a caged look.
  • Weld mesh, a grid of welded steel wire in rolls or panels, is the lightest and least expensive. It suits side and back boundaries, gardens, paddocks and sports fields.

A common pattern is palisade or ClearVu-type mesh where the property faces the road, with weld mesh along the less exposed sides, which keeps the cost down where the risk is lower. More on each kind is on weld mesh fencing and steel palisade fencing.

A dark mesh fence around a townhouse complex with a planted garden in front

Fencing Benoni's properties

Suburban homes in Northmead, Farrarmere and Benoni Western Extension usually fence the street front, often between brick pillars, with a driveway gate and a pedestrian gate in the same profile. Height is the first decision: a low fence marks the boundary, while one at head height or above is meant to keep people out.

Smallholdings and acreage towards Rynfield and Crystal Park have boundaries that run for hundreds of metres. Weld mesh in rolls follows uneven ground and keeps the cost per metre down; palisade or ClearVu-type mesh is kept for the road frontage and the gate.

Business premises in the industrial areas to the south, such as Apex, want palisade or ClearVu-type mesh at the street, wide driveway gates for trucks, and often an electric fence along the top.

Complexes in Lakefield, Brentwood Park or Morehill are well served by ClearVu-type mesh on the perimeter: it stays see-through for patrols and neighbours while being very hard to climb.

A new black steel palisade fence and sliding gate along a suburban property

Gates, motors and electric strands

A steel fence usually needs a driveway gate and a pedestrian gate, made to match it. We hang both, and because we also install gate motors, the driveway gate can be built for its motor from the start: a straight bottom rail for the rack on a sliding gate, or posts strong enough for the arms on a swing gate. See gate motors in Benoni.

An electric fence can run along the top of palisade or mesh, on brackets bolted to the posts, insulated from the steel, which is earthed. It turns a fence that can be climbed into one that alarms at the top, and suits business boundaries in particular. See electric fences in Benoni.

How a steel fence goes up

  1. Confirm the line. The boundary is checked before anything is dug, because a fence built a little over the line is an expensive mistake.
  2. Set the posts in concrete at the spacing the panels or pales need, then let the concrete cure.
  3. Fit the fence: rails and pales for palisade, clamped panels for ClearVu-type and panel mesh, or straining wires and tensioned rolls for weld mesh.
  4. Hang the gates and check they swing or slide freely and latch.
  5. Touch up every cut or drilled edge so the bare steel doesn't rust.

Slopes are either followed or stepped, and the bottom edge is kept close to the ground so dogs can't get out and nobody can get under.

Technicians installing tall mesh security fence panels along a boundary

Repairs to palisade and mesh

Steel fencing lasts, but it gets damaged: a car reverses into a post, someone cuts out a pale or a panel to get in, bolts and clamps go missing, and rust starts at the base where sprinklers and wet grass keep the steel damp. We replace pales and panels, reset leaning posts, re-tension sagging roll mesh, treat rust and repaint, and repair gates that drag. A damaged section doesn't mean replacing the whole fence. Six-month guarantee on our repairs.

What steel fencing typically costs

Typical market prices in Gauteng, supplied and installed, not ours:

  • steel palisade, all heights: R1 100–R2 400 a metre (ProCompare); R1 200–R2 500 a metre (Completo)
  • 1.8 m palisade: R1 800–R2 200 a metre (Kandua); R1 980–R2 420 a metre (LocalPros)
  • ClearVu-type high-security mesh: R1 300–R1 600 a metre (ProCompare); R1 200–R1 700 a metre (Completo)
  • weld mesh: R600–R800 a metre (ProCompare)
  • a steel pedestrian gate: R2 500–R6 000 (Completo)

Height, finish, pillars, slopes and the number of gates move the total. Prices checked October 2026. Your exact price is set in a free quote before any work starts. No call-out fee when we do the work. If no work is done, a R650 call-out fee applies.

Booking a fencing quote in Benoni

On the job card, tell us roughly how long the boundary is, which kind of fence you have in mind, where the gates go and whether an electric fence will go on top, now or later. A few photos along the boundary help us quote close to the final figure. For a repair, a photo of the damage is enough to start.

Same-day repairs are part of the normal week in Benoni for fence and gate damage, whenever the day's bookings allow.

Questions

Fencing questions in Benoni

Do you install ClearVu fencing in Benoni?

Yes, we install ClearVu-type high-security mesh, the anti-climb panels with openings too narrow for fingers, on homes, complexes and business premises across Benoni. It suits a boundary that must stay see-through. Compare the fence types.

Is palisade or ClearVu better for a Benoni business?

Both suit business premises. Palisade is stronger against a vehicle and a clear deterrent; ClearVu-type mesh is harder to climb or cut and lets you see the property from the street. Either can carry an electric fence on top. Read about fencing business premises.

Can you fence a long smallholding boundary in Benoni?

Yes. Weld mesh in rolls suits a long boundary, because it follows uneven ground and costs less per metre, with palisade or ClearVu-type mesh kept for the road frontage and the gate. Read about smallholdings.

Can you repair a damaged palisade fence in Benoni?

Yes. We replace cut or bent pales and panels, reset posts hit by a vehicle, treat rust and repair the gates, so one damaged section doesn't mean a new fence. Send a photo of the damage when you book. Read about repairs.

Book a technician

Get a palisade fencing quote in Benoni

Job card

We WhatsApp or call you back. Fields marked (required) are needed.

Property type
When
Photos (optional, up to 4)

No call-out fee when we do the work. If no work is done, a R650 call-out fee applies.