Skip to content

24/7 emergency repairs across Gauteng

081 566 5451

Palisade and weld mesh · East Rand

Palisade fencing on the East Rand: prices, quotes and installation

A 2.4 m palisade line around a yard in Isando, weld mesh down the side of a house in Edleen, a run of pales cut out of a fence in Reiger Park: we quote, install and repair steel fencing across the East Rand.

Our promise

Six-month guarantee on our repairs

East Rand

East Rand and the areas around it. Every area we cover

Palisade fencing prices on the East Rand

What steel fencing typically costs in Gauteng, per metre of finished fence, supplied and installed unless it says otherwise. These are market prices from published cost guides, not ours:

Steel fencing, typical prices per metre
FenceTypical price
Steel palisade (all heights)R1 100–R2 400 a metre (ProCompare); R1 200–R2 500 a metre (Completo)
Steel palisade 1.8 mR1 800–R2 200 a metre (Kandua); R1 980–R2 420 a metre (LocalPros)
Steel palisade 2.4 mR2 000–R3 000 a metre (Kandua)
Steel palisade with pillarsR3 100–R3 800 a metre (ProCompare)
Weld meshR600–R800 a metre (ProCompare)
Labour only, palisadeR250–R700 a metre (Kandua)

A steel pedestrian gate typically adds R2 500–R6 000 (Completo). Prices checked October 2026. Your exact price is set in a free quote before any work starts. No call-out fee when we do the work. If no work is done, a R650 call-out fee applies.

A new black steel palisade fence and sliding gate along a suburban property

What a fair fencing quote lists

A per-metre rate is a starting point, not a price. A quote you can rely on spells out:

  • The length, measured on site, for each type and height of fence, rather than guessed from a plan.
  • The fence itself: its height, the steel, and the finish, whether galvanised, powder-coated or both.
  • The posts: how far apart they are and that they're set in concrete.
  • Each gate on its own line, with its width, and whether it's built to take a motor.
  • The groundwork: slopes, rock, brick pillars, and taking away an old fence and its rubble.
  • Brackets for an electric fence, if one is going on top now or later.
  • What isn't included, and how long the price holds.

Comparing two quotes

Two quotes for the same boundary can be far apart, and the cheaper one isn't always the better buy. Before choosing, line them up item by item. Did both measure the same length? Is it the same height, and the same finish, since a painted fence that isn't galvanised underneath costs less now and more later? Are the posts as close together and set as deep in concrete? Are the gates, pillars and removal of the old fence included in both, or extra in one? A quote that leaves these out isn't cheaper; it's unfinished.

Keeping the cost down

There are honest ways to spend less on a fence without weakening it where it counts:

  • The strongest fence where it's needed. Palisade or ClearVu-type mesh on the street front and around the yard; weld mesh, which costs much less per metre, on side and back boundaries.
  • The right height for each boundary. A 2.4 m fence on a quiet internal boundary costs more than it earns.
  • Phases. A long perimeter can go up front first, then the sides, as the budget allows.
  • Repair, don't replace. Sound stretches of an old fence can stay, with only the damaged sections renewed.
  • Labour only, if you've already bought the steel. We check it before fitting, since a fence is only as good as its material.
A dark mesh fence around a townhouse complex with a planted garden in front

Factories, yards and complexes

Around factories and yards in Isando, Spartan and Germiston, the usual brief is 2.4 m palisade along the boundary, a wide sliding gate for trucks with a pedestrian gate beside it, and often an electric fence on top. For townhouse complexes, the shared perimeter is the body corporate's, and we price it for the trustees, stretch by stretch, so it can be approved and done in stages.

After you accept the quote

We mark the line with you on site, then set the posts in concrete and let them cure before the fence goes on. Pales are bolted to their rails, or mesh panels clamped to their posts, and the gates are hung and checked so that a motor can be added. Every cut end is treated against rust, because that's where rust starts, and the site is cleared before we leave. If the gate is to be automated, see gate motors on the East Rand.

Palisade and mesh repairs

Steel fences get hit by vehicles, cut through by intruders, robbed of their bolts and clamps, and rusted at the base where water lies. We replace the damaged section in matching steel and finish, re-set leaning posts, and fix any electric fence on top that came down with it. A fence that's been cut or driven through can be booked as urgent. Six-month guarantee on our repairs.

Booking a fencing quote on the East Rand

On the job card, give a rough length for each side, the fence you have in mind, the gates, and a photo or two of the boundary. We quote across the East Rand, from Primrose, Germiston and Elsburg to Reiger Park, Boksburg and Sunward Park, from Esther Park, Edleen and Kempton Park to Rhodesfield and Bonaero Park, and on to Brakpan, Springs and the industrial areas around Isando and Spartan. Same-day repairs can be arranged when the day's bookings allow.

Questions

Fencing questions on the East Rand

How much does palisade fencing cost on the East Rand?

Typical Gauteng market prices are R1 100–R2 400 a metre (ProCompare); R1 200–R2 500 a metre (Completo) supplied and installed, depending on height, finish and the site. Your exact price is set in a quote before any work starts. See typical prices.

Why are two palisade quotes for the same boundary so different?

Often they don't cover the same thing: a different length, height or finish, posts further apart, or gates and removal left out of one. Compare them item by item. Read about comparing quotes.

Can I buy the palisade myself and pay for labour only?

Yes. Labour alone typically costs R250–R700 a metre (Kandua) in the market. We check the steel before fitting it. Read about keeping costs down.

Is weld mesh cheaper than palisade?

Yes, per metre it typically costs much less, which is why it suits side and back boundaries, with palisade or ClearVu-type mesh kept for the street front. Read about keeping costs down.

Book a technician

Get a palisade fencing quote in East Rand

Job card

We WhatsApp or call you back. Fields marked (required) are needed.

Property type
When
Photos (optional, up to 4)

No call-out fee when we do the work. If no work is done, a R650 call-out fee applies.