Skip to content

24/7 emergency repairs across Gauteng

081 566 5451

Guides · Electric fencing

Electric fence beeping: what the beeps mean and how to stop them

An electric fence energizer has a buzzer inside, and often a keypad that beeps too. Some beeps mean an alarm, some mean the power is off, some mean the battery is running down, and some just mean the gate opened. Here's how to tell which from the pattern and the lights, what to do about each, and when the beeping is a sign the fence needs us.

Our promise

2-year warranty and a compliance certificate on every new electric fence we install

Emergency

24/7 emergency repairs across Gauteng

A technician shining a torch on the terminals of an open electric fence energiser box in a garage

Match the beep to its meaning

Common energizer and keypad beeps, from Nemtek's and JVA's manuals
What you hearWhat it usually means
Continuous beeping with the siren or strobeA fence or gate alarm
Beeping with no siren, and a service lightA service condition, often a low battery after a power cut
A few warning beeps during a long power cutThe energizer switching to low power to save the battery (JVA: four beeps)
Three beeps when the gate opens (two when it closes, on a Merlin)The gate chime, which is a feature, not a fault
Fast beeping while entering a codeYou paused too long and the keypad forgot the code
Five beeps after a codeThe PIN was wrong (Merlin)
One beep on, two off (Wizord, with the tab)The fence switching on or off

The lights on the energizer or keypad tell you the rest. On Nemtek's energizers the rule is simple: a flashing alarm light means the fault is still there; a steadily lit one means it happened and has passed.

Beeping because of an alarm

When the fence voltage drops below the alarm level, or a gate stays open past its delay, the energizer sounds its internal buzzer, any keypad beeper and the siren. JVA's Z-series describes it plainly: the zone light flashes and then stays on, and the siren and keypad beeper sound. The cause is on the fence or the gate: plants touching the wires, a broken wire, a fallen branch, a gate left open, or a short to the earth wire.

Silencing it with your code or Nemtek's tab stops the noise, but if the alarm light is still flashing, the fault is still there and it will alarm again when re-armed. Our guide to an electric fence alarm that keeps going off goes through finding the cause.

Beeping because of the power or the battery

Energizers run from a battery that the mains keeps charged. When the mains fails, many beep or show a warning; as the battery runs down, the warnings change:

  • Nemtek's Wizord lights its power LED with mains present and turns it off in a failure; a long outage runs the battery low and flashes the service light, which sounds the buzzer without the siren. If the outage is long enough, the unit shuts down altogether.
  • JVA's Z-series gives four warning beeps before dropping into low-power mode to keep the fence going, stops if the battery keeps falling, and gives four beeps again when it re-arms itself once the power is back.

So beeping during or after load shedding is often the energizer telling you about its battery. If it carries on long after the mains is back, the battery may no longer hold a charge. See electric fence after load shedding.

Beeps that are working as intended

  • The gate chime. Druid and Merlin energizers can beep when the gate opens: three beeps on a Druid, three on opening and two on closing on a Merlin. If that annoys you, the master user can switch it off from the keypad.
  • Code entry. Druid keypads beep twice when a code is accepted and beep fast if you pause more than five seconds; Merlin keypads beep five times at a wrong PIN.
  • Silent alarm. On a Druid, silent alarm stops the siren and strobe but deliberately keeps the internal beeper, so an alarm still sounds inside.
  • Battery test. A Merlin beeps four times when a battery test starts.

How to change these from the keypad is on the Nemtek Druid and Nemtek Merlin pages.

Safe checks when it won't stop

  1. Read the lights on the energizer and keypad, and note which are flashing and which are steady.
  2. Check the mains to the energizer: the plug, its switch and the distribution board.
  3. Walk the fence line from a safe distance, looking for plants, branches, broken wires and an open gate.
  4. Silence it with your code or tab, clear anything you safely can, and re-arm.
  5. Watch whether it starts again. Straight away means a fault still on the fence; hours later, after a power cut, points to the battery.

Don't touch the fence wires, and don't open the energizer: it stores a dangerous charge and carries mains-derived power.

When to call us

Call us when the beeping comes back as soon as you re-arm, the service light stays on after a day with the mains on, the energizer beeps with no lights at all, or the fence seems dead. We find the fault on the fence or in the energizer, replace batteries, earth systems and insulators, and repair or replace energizers and keypads. A fence that beeps and alarms all night is covered by our 24/7 emergency repairs across Gauteng, and every repair carries our six-month guarantee on our repairs. No call-out fee when we do the work. If no work is done, a R650 call-out fee applies.

Questions

Questions about electric fence beeping

Why is my electric fence beeping?

Usually an alarm from the fence or gate, a power failure, or a battery running low; sometimes it's just the gate chime. The energizer's lights tell you which: a flashing alarm light means the fault is still there. Match the beep.

Why does my electric fence keep beeping?

If it starts again as soon as you re-arm, a fault is still on the fence, such as plants or a broken wire; if it beeps during or after load shedding, the battery is running low or no longer holds a charge. See power and battery beeps.

What could be causing my electric fence to beep?

A fence or gate alarm, a mains failure, a low battery or service condition, a wrong keypad code, or the gate chime, which is a feature. See beeps that are working as intended.

Book a technician

Get an electric fence quote

Job card

We WhatsApp or call you back. Fields marked (required) are needed.

Property type
When
Photos (optional, up to 4)

No call-out fee when we do the work. If no work is done, a R650 call-out fee applies.