Skip to content

24/7 emergency repairs across Gauteng

081 566 5451

Palisade and weld mesh · Roodepoort

Palisade fencing in Roodepoort, with ClearVu-type and weld mesh

ClearVu-type mesh round a complex in Strubensvalley, palisade stepping down a sloping street front in Helderkruin, weld mesh along a boundary that backs onto open ground in Little Falls, a perimeter for a yard on Main Reef Road: we supply and install steel fencing across Roodepoort, with gates to match.

Our promise

Six-month guarantee on our repairs

Roodepoort

Roodepoort and the areas around it. Every area we cover

ClearVu-type mesh in Roodepoort

Roodepoort searches for ClearVu by name. It's made as rigid panels of thick wire with openings too narrow for fingers or the toe of a shoe, so there's nothing to grip and it's slow to cut. From a few metres away it almost disappears, which suits a boundary where you want security without hiding the view, whether that's a garden looking out over a kloof or a complex perimeter that patrols need to see through.

It's fixed with clamps to posts set in concrete, and it's the most expensive of the steel fences per metre, so it can be kept for the most exposed stretches: the street front, the entrance and any side open to a public path. More on it is on weld mesh fencing, which covers anti-climb mesh alongside ordinary weld mesh.

A dark mesh fence around a townhouse complex with a planted garden in front

Weld mesh for long and open boundaries

Ordinary weld mesh, a welded wire grid in rolls or panels, is the economical choice for the sides and back of a property, and for boundaries that back onto open veld, a nature area or a neighbour's garden. Rolls follow uneven ground well, which helps on Roodepoort's slopes; panels give a straighter, stiffer line. The bottom edge is kept close to the ground, or set on a low concrete strip where the ground drops away, so dogs stay in and nothing gets under.

Palisade on a sloping street front

Palisade, vertical steel pales with pointed tops bolted to rails between posts, is the strongest of the three and the clearest deterrent, and it suits a street front or an entrance that a car could be driven at. On a sloping street it's either stepped, each panel level and set lower than the last, or raked to follow the slope; stepping keeps the pales upright and looks neater from the street, raking leaves no gaps at the bottom. We'll show you both on the visit.

Palisade can run between brick pillars, and an electric fence can run along the top on brackets, insulated from the steel. For the electric side, see electric fences in Roodepoort.

A new black steel palisade fence and sliding gate along a suburban property

Estates, complexes and industrial sites

Estates set rules for fences inside them, and usually look after their own perimeter; check the height, colour and type allowed with the managing agent before ordering.

Complexes fence one perimeter for many homes, and can mix types: ClearVu-type mesh or palisade along the street and entrance, weld mesh down the sides.

Industrial sites along Main Reef Road want tall palisade or ClearVu-type mesh on deep posts, wide sliding gates for trucks, a pedestrian gate for staff, and often an electric fence on top.

For all three, the gates, the gate motor, the boom and the intercom are best planned with the fence. Everything else we do in the area is on our Roodepoort page.

Technicians installing tall mesh security fence panels along a boundary

From survey to finished fence

  1. Survey: the boundary is measured and confirmed, with the slope, pillars, gates and buried services marked.
  2. Posts: set in concrete at the spacing the fence needs, stepped or raked on a slope, and left to cure.
  3. The fence: pales on rails, clamped mesh panels, or tensioned mesh rolls.
  4. Gates: hung, checked, and built ready for a motor if they'll be automated. A steel pedestrian gate typically costs R2 500–R6 000 (Completo) in the market.
  5. Finish: cut and drilled steel touched up against rust, and the site cleared.

Repairs

We repair what has been damaged rather than replacing the whole fence: a section hit by a vehicle, pales or panels cut out, posts loosened on a slope after heavy rain, missing clamps and bolts, and rust where the steel stays wet. Six-month guarantee on our repairs.

What steel fencing typically costs

Typical market prices in Gauteng, supplied and installed, not ours:

  • ClearVu-type high-security mesh: R1 300–R1 600 a metre (ProCompare); R1 200–R1 700 a metre (Completo)
  • weld mesh: R600–R800 a metre (ProCompare)
  • steel palisade, all heights: R1 100–R2 400 a metre (ProCompare); R1 200–R2 500 a metre (Completo)
  • a ClearVu-type panel kit (1.8 × 2.5 m), in shops: about R4 600 (Takealot)

Prices checked October 2026. Your exact price is set in a free quote before any work starts. No call-out fee when we do the work. If no work is done, a R650 call-out fee applies.

Booking a fencing quote in Roodepoort

On the job card, give the rough length of the boundary, how steep it is, the fence you have in mind and where the gates go. Photos along the line help us quote close to the final figure. We work across Roodepoort, from Florida and Horison to Wilro Park, Strubensvalley and Little Falls. Same-day repairs are part of the normal week here for fence and gate damage, whenever the day's bookings allow.

Questions

Fencing questions in Roodepoort

Do you install ClearVu fencing in Roodepoort?

Yes, ClearVu-type high-security mesh for homes, complexes and industrial sites across Roodepoort, on the street front and entrance with weld mesh on the sides where that suits. Read about ClearVu-type mesh.

Can palisade be installed on a sloping driveway or street front?

Yes. It's either stepped, with each panel level and set lower than the last, or raked to follow the slope; stepping looks neater, raking leaves no gaps at the bottom. Read about palisade on a slope.

What fence suits a boundary that backs onto open veld?

Weld mesh is the economical choice for long or open boundaries, in rolls that follow uneven ground, with its bottom edge kept close to the ground. An electric fence can be added on top. Read about weld mesh.

How much does ClearVu fencing cost per metre?

Published cost guides put ClearVu-type high-security mesh at R1 300–R1 600 a metre; R1 200–R1 700 a metre supplied and installed (prices checked October 2026), against R600–R800 a metre for ordinary weld mesh. See typical prices.

Book a technician

Get a palisade fencing quote in Roodepoort

Job card

We WhatsApp or call you back. Fields marked (required) are needed.

Property type
When
Photos (optional, up to 4)

No call-out fee when we do the work. If no work is done, a R650 call-out fee applies.