Skip to content

24/7 emergency repairs across Gauteng

081 566 5451

Palisade and weld mesh · Douglasdale

Palisade fencing in Douglasdale, and gates built for their motors

Palisade along the street front of a family home near Epsom Downs, a sliding gate that drags on its track by Magaliessig, a small fence around a townhouse garden: we supply, install and repair steel fencing and gates across Douglasdale.

Our promise

Six-month guarantee on our repairs

Douglasdale

Douglasdale and the areas around it. Every area we cover

Street fronts and complex gardens

On a Douglasdale family home, steel tends to go along the street front: palisade or ClearVu-type mesh instead of a solid wall, or on top of a low one, so the garden gets light and the house can be seen from the road. Around a complex, the perimeter is the body corporate's. Inside it, owners sometimes want a small fence and gate around their own garden, for children or a dog; that needs the body corporate's approval, and should match the complex's steel and colour.

A new black steel palisade fence and sliding gate along a suburban property

A sliding gate built for its motor

A motor can't make up for a badly hung gate. Centurion's installation manual for its D2 Turbo, a motor for lighter sliding gates, sets out what the gate itself needs before a motor goes on:

  • It runs freely, and doesn't roll by itself when left anywhere along the track.
  • Guide rollers hold it upright, with an extra support post so it can't fall over if a roller fails.
  • Anti-lift brackets stop it being lifted off the motor's pinion, set less than 5 mm from the gate.
  • End stops at both ends, strong enough to stop the gate at full speed and tall enough that it can't jump over them. Centurion calls them mandatory.
  • The motor goes on the inside, never where the public can reach it, with room for the gate beside it when fully open.

The gate's weight, and the force it takes to start it moving and keep it moving, decide which motor suits it: the D2 Turbo, for example, takes gates up to 250 kg. We build the gate with the motor's needs in mind, so the track, rollers and stops are right from the start. Motors are on gate motors in Douglasdale.

Gloved hands fitting a steel gear rack along the bottom of a sliding gate, the motor's pinion gear beside it

Getting in on foot

For people on foot, one answer is a separate steel pedestrian gate beside the main gate, with its own lock. The other is the motor's pedestrian opening: some motors, the D2 Turbo among them, can open the main gate just part of the way, from a remote button, a keypad or a keyswitch, and close it again after a set time. It saves building a second gate, but every trip on foot then works the motor.

When an electric fence runs along the top

Where an electric fence runs along the steel and across the gate, a contact on the gate tells the energiser whether the gate is shut. The D2 Turbo has a positive close mode for this, so it closes the gate firmly enough to make that contact every time. Electric fences in Douglasdale have a page of their own.

Repairs to steel fences and gates

Steel takes knocks: a car reversing into the pales, a gate that drags because a roller has worn or the track has shifted, a hinge worn through on a swing gate, rust where the galvanising was cut. We straighten or replace pales and panels, re-set leaning posts, replace rollers and track, re-hang gates and treat the steel. Six-month guarantee on our repairs.

What steel fencing typically costs

Typical market prices in Gauteng, from published cost guides, not ours:

  • Steel palisade 1.8 m, supplied and installed: R1 800–R2 200 a metre (Kandua); R1 980–R2 420 a metre (LocalPros)
  • ClearVu-type high-security mesh, supplied and installed: R1 300–R1 600 a metre (ProCompare); R1 200–R1 700 a metre (Completo)
  • Steel pedestrian gate: R2 500–R6 000 (Completo)

Prices checked October 2026. Your exact price is set in a free quote before any work starts. No call-out fee when we do the work. If no work is done, a R650 call-out fee applies.

Booking a fencing quote in Douglasdale

On the job card, give the rough length of the run, the gates you need and whether a motor will drive them; a photo or two helps, and for a complex, add who will meet us. We quote across Douglasdale, from Epsom Downs and Magaliessig to Maroeladal, Jukskei Park and Cowdray Park. Same-day repairs can be arranged for a gate or fence that has been driven into, when the day's bookings allow.

Questions

Fencing questions in Douglasdale

What does a sliding gate need before a motor is fitted?

It must run freely and stay where it's left, with guide rollers, anti-lift brackets and an end stop at each end. Read about gates.

What does an anti-lift bracket on a sliding gate do?

It stops anyone lifting the gate off the motor's pinion to push it open. Centurion asks for a gap of less than 5 mm between bracket and gate. Read about gates.

Can a gate motor open the gate partly for people on foot?

Some can: Centurion's D2 Turbo has a pedestrian opening that opens the gate part of the way and closes it after a set time. Read about getting in on foot.

Can I put a fence around my own garden in a complex?

Usually, with the body corporate's approval, in steel and a colour that match the complex. Read about complex gardens.

Book a technician

Get a palisade fencing quote in Douglasdale

Job card

We WhatsApp or call you back. Fields marked (required) are needed.

Property type
When
Photos (optional, up to 4)

No call-out fee when we do the work. If no work is done, a R650 call-out fee applies.