Skip to content

24/7 emergency repairs across Gauteng

081 566 5451

Brands · BPT

BPT intercom repairs for houses, complexes and apartment blocks

BPT door entry systems are Italian-made and built to last, which is why so many are still on gate pillars and complex entrances years after they were fitted. When one fails, it's usually a single part: an entrance panel that let water in, a handset in one unit, a power supply or a cable. We repair BPT intercoms on houses and on multi-unit entrances, and upgrade them when a repair no longer makes sense.

Our promise

Six-month guarantee on our repairs

Emergency

24/7 emergency repairs across Gauteng

A hand entering a code on a steel keypad pedestal beside a driveway gate

How a BPT system is put together

Whether it serves one house or forty flats, a BPT installation has the same building blocks:

  • The entrance panel at the gate or the front door, with a call button for each home or a keypad, a speaker and microphone, and often a camera.
  • An indoor unit in each home: an audio handset or a video monitor, each with a button that opens the gate or door.
  • A power supply, usually in a cabinet near the entrance or in the guardhouse, which feeds the panel and, on many systems, the indoor units.
  • The cabling that links them, run underground from the gate on a house, or through the building's risers on a complex.
  • The release: a relay that triggers the gate motor or a door lock.

A complex system adds a controller that sends each call to the right home. That's useful to know when something fails, because a fault in a shared part affects everyone, while a fault in one home's unit or cable affects only that home.

A hand entering a code on a steel keypad pedestal beside a driveway gate

Why a BPT intercom keeps beeping

A BPT that beeps or rings on its own is usually reacting to something real, even if nobody's at the gate:

  • A call button held in, because it's stuck, swollen after rain or has dust and grit behind it.
  • Water inside the entrance panel, shorting the button contacts, which often shows up only after a storm or on a misty morning.
  • A damaged cable where cores touch, which can come and go with the weather.
  • An indoor unit that has been knocked off its hook, on handset models, which some units signal with a tone.

Check the panel from the outside first: does every button spring back, is there condensation behind the front, is the case cracked or the seal missing? If the beeping started after rain, water is the likely cause, and a panel that has let water in will usually do it again unless its seal and mounting are fixed.

Other BPT faults we repair

  • One home can't be called: that home's indoor unit or its cable, not the whole system.
  • Nobody can be called: the entrance panel, the shared power supply or the controller.
  • You can hear the visitor but they can't hear you, or the other way round: the microphone or speaker on one side, or a cable core.
  • Sound but no picture on a video system: the camera in the panel, the video cable or the monitor.
  • It calls but won't open the gate: the release relay, its wiring to the gate motor, or the motor's input. Try the gate with a remote first.
  • The entrance panel has been vandalised or burnt by a lightning surge.
  • Completely dead: the power supply, its fuse or the mains to it.

All our spare parts are genuine where the parts are still made, and every repair carries our six-month guarantee on our repairs.

Safe checks before you call

  1. Power. Is the indoor unit's adaptor plugged in and switched on? On a complex, ask whether other homes have the same problem: if they do, the shared power supply is the likely cause, not your unit.
  2. The handset. Is it properly on its hook, and is the volume or ringer turned up?
  3. The entrance panel. Look for stuck buttons, water, cracks or burn marks, without opening it.
  4. The gate. If the intercom calls but won't open the gate, try a remote. If the remote doesn't work either, the gate motor is the problem: see intercom not working for the general checks.

Don't open the panel or the power supply cabinet: both carry power, and a wrong connection can damage every unit on the system.

BPT in complexes and apartment blocks

On a multi-unit BPT system, the trustees or the managing agent usually look after the entrance panel, the controller, the power supply and the cable in shared areas, and owners look after the unit in their own home. We report back on which side a fault falls, so the right party is quoted.

A complex entrance that stops working leaves residents unable to let visitors in, and sometimes leaves the gate open. That's covered by our 24/7 emergency repairs across Gauteng. For planning an upgrade or a new system, see intercom systems for complexes, and for gates, booms and maintenance contracts, estates and complexes.

Repair or upgrade?

A BPT system is usually worth repairing when the fault is in one part: one handset, the entrance panel's buttons, the power supply or a single cable run. The cabling is the expensive part to replace, especially in a building, so keeping it is worth a lot.

It's time to think about an upgrade when parts for an older system are no longer available, when several units have failed at once after a surge, or when residents want video or calls to their phones. Often the existing cable can carry a newer system, which keeps the cost down. Typical figures in the market for a single home:

  • Basic audio intercom: R2 500–R5 000 (Kandua)
  • Video intercom: R5 000–R15 000+ (Kandua)
  • GSM gate module, installed: R1 500–R3 000 (published price lists of Gauteng installers)

These are the market's figures, not ours. Prices checked October 2026. Your exact price is set in a free quote before any work starts. No call-out fee when we do the work. If no work is done, a R650 call-out fee applies.

Booking a BPT repair

We repair BPT intercoms across Johannesburg, the East Rand and Centurion, alongside Centurion, Commax, Zartek and Kocom systems and the gate motors they open. Tell us what the intercom is doing, whether it's a house or a complex, and send a photo of the entrance panel and an indoor unit if you can. No call-out fee when we do the work. If no work is done, a R650 call-out fee applies.

More on our intercom work on intercoms, and the other makes on brands we work on. Repairs Plus is an independent installer and repairer. We are not the manufacturer.

Fault finder

What is your BPT doing?

Pick what you're seeing for the likely causes, the safe checks you can do yourself, and when to stop and book. Taken from the manufacturers' own manuals.

What's it doing?

Likely causes

Intercom · the handset can't reach the gate unit

Most likely first

  1. No power to the gate (caller) unit.

  2. The handset's battery has run down.

  3. Too far apart, or a lot of steel in between.

  4. The handset and gate unit have lost their pairing.

Safe checks you can do

When to stop and book

Re-pairing a system or moving a unit for better range is a quick job on the visit.

Questions

Questions about BPT

Why does my BPT intercom keep beeping?

Usually a call button is stuck or water has got into the entrance panel, shorting the button's contacts; a damaged cable or a handset off its hook can do the same. Check the panel from outside without opening it. Read why it beeps.

Only my flat can't be called on our BPT system. Is that the complex's problem?

Usually not: if other homes can be called, the fault is in your indoor unit or the cable to your home, which is normally the owner's to fix. If nobody can be called, it's the shared equipment. See BPT in complexes.

Can an old BPT intercom be upgraded to video?

Often, yes, and frequently over the existing cable, which keeps the cost down. We check the cable and the system before quoting. See repair or upgrade.

Book a technician

Get an intercom quote

Job card

We WhatsApp or call you back. Fields marked (required) are needed.

Property type
When
Photos (optional, up to 4)

No call-out fee when we do the work. If no work is done, a R650 call-out fee applies.